|
 HK91.COM
 HK-Compatible Guns
 Will a clip/pinned 0-1-25 HK 33 housing fit...
|
 UBBFriend: Email This Page to Someone! |
next newest topic | next oldest topic |
| Author | Topic: Will a clip/pinned 0-1-25 HK 33 housing fit... |
|
badkarma6 Member Posts: 43 |
posted 08-03-2001 21:43
  
I know a SEF housing can be made to fit a 94 or a 91. Is the same true for the 0-1-25? If the housing is clipped, will it fit on any of the above or just the 93? Thanks IP: Logged |
|
spnkmyvr Member Posts: 57 |
posted 08-03-2001 21:54
The housing you refer to should fit. From what Ive learned about these rifles, the housing should fit all of the weapons, with a few exceptions. You really just need to use a compatable trigger pac with the housing. IP: Logged |
|
MJD Member Posts: 37 |
posted 08-03-2001 22:17
The 93/94 housings do have a smaller tail than the 91 series but it will still work if clipped to clear the receiver shelf. I don't own a 91 personally but have clipped a few lowers for some folks and haven't heard of any problems the smaller tails make with these weapons... Michael IP: Logged |
|
TACO Member Posts: 14 |
posted 08-08-2001 15:14
The clip and pins I have seen for clones were cut more than those for a HK 91/93/94 I was in-correct. Now that I look at my Navy housing I can see that has had metal removed. It is just milled so cleanly that it appeared that the metal was the original thinkness. I was refering to the gunshow SW5 and such I had looked at. They were cut much looser than my Navy/93. I thought they were done that way out of need, maybe they were just quick and dirty. [This message has been edited by TACO (edited 08-11-2001).] IP: Logged |
|
MJD Member Posts: 37 |
posted 08-09-2001 11:02
TACO, Haven't done too many clones but I think for the most part, they're the same. You do have to remove ALMOST all the metal too even for HKs. I have a few that have a very, very, very thin layer of metal left but usually it all comes out due to it being so thin. I haven't heard if the clones have a wider shelf area but I'd expect they do not. I sold a SEF clipped housing for my MP5 that mated to a Special Weapons SW5 without any problems or additional milling. Any clone in particular you were talking about? - again, I have very little experience in dealing with these - most of mine are all HK. Michael IP: Logged |
|
spnkmyvr Member Posts: 57 |
posted 08-09-2001 11:44
I pinned and clipped a navy lower for my Interport, and it will also fit my 91. The shelf is exactly the same measurements both in width and hight. IP: Logged |
All times are CT (US) | next newest topic | next oldest topic |
  |
|
Contact Us | HK91.COM
© 1999-2000 HK91.com
Ultimate Bulletin Board 5.46